Uruguay (EN)

AIR-SAVER-LS


Light Switch

The AIR-SAVER-LS (Light Switch) is controlled via an internal relay which is opened and closed by an external switch and connected to its own power supply. A typical installation example is to connect the AIR-SAVER-LSto a light switch.

By switching the lights on in the production area theAIR-SAVER-LS will open automatically. The compressed air, which is saved in the air receiver, flows into the compressed air system and the compressor subsequently only kicks-in to build up the pressure in the system. At the end of the work-shift - when the lights are switched off - the AIR-SAVER-LSwill close automatically.

Benefits are:

  • potential daily saving of at least one air receiver’s worth of compressed air.
  • Compressor, dryer and filter activities are avoided during factory closing hours.
  • No unnecessary compressor start-ups during periods when compressed air is not required.
  • Reduced maintenance requirements and lower power consumption leads to considerable savings on service and energy costs.

The AIR-SAVER-LS is typically installed directly after the air receiver, but it can also be installed at the air inlet point to each department which uses compressed air.


en-UY