TheAIR-SAVER-LS (Light Switch) is controlled via an internal relay which is opened and closed by an external switch and connected to its own power supply.
A typical installation example is to connect theAIR-SAVER-LS to a light switch. By switching the lights on in the production area theAIR-SAVER-LS will open automatically.
The compressed air, which is saved in the air receiver, flows into the compressed air system and the compressor subsequently only kicks-in to build up the pressure in the system.
At the end of the work-shift - when the lights are switched off - the AIR-SAVER-LSwill close automatically.
TheAIR-SAVER-LS is typically installed directly after the air receiver, but it can also be installed at the air inlet point to each department which uses compressed air.