jorc
How can we help you?

AIR-SAVER-LS

Light Switch

TheAIR-SAVER-LS (Light Switch) is controlled via an internal relay which is opened and closed by an external switch and connected to its own power supply.

A typical installation example is to connect theAIR-SAVER-LS to a light switch. By switching the lights on in the production area theAIR-SAVER-LS will open automatically.
The compressed air, which is saved in the air receiver, flows into the compressed air system and the compressor subsequently only kicks-in to build up the pressure in the system. 
At the end of the work-shift - when the lights are switched off - the AIR-SAVER-LSwill close automatically.

ls-news1.png
Benefits are:
- A potential daily saving of at least one air receiver’s worth of compressed air.
- Compressor, dryer and filter activities are avoided during factory closing hours.
- No unnecessary compressor start-ups during periods when compressed air is not required.
- Reduced maintenance requirements and lower power consumption leads to considerable savings on service and energy costs.

 

TheAIR-SAVER-LS is typically installed directly after the air receiver, but it can also be installed at the air inlet point to each department which uses compressed air.